Hey guys,
I've spent a lot of time doing a Taito project. I have run into a weird problem. Didn't know this about Taito cabinets.
I actually rotated the horizontal monitor to a vertical setup, but now the frame sticks out the back and the door won't close.
After a little research, I've discovered that this is common and that Taito used a "shroud" to go over the hole they cut out of the door.
However, I can't find a picture of the back of a taito cab that has this shroud over it.
Could someone please upload a picture of the back of a Taito cabinet that has this vertical monitor shroud on it? I think I'm going to either have to cut the door or hack up my monitor frame.
If I cut the door, I'll need to locate one of those "shrouds" or make one, but I have no clue what they look like on the back of the cabinets.
Does anybody have a Taito cabinet with one of those bubbles on it? I need a pic to go by if I cut up my door.
I've spent a lot of time doing a Taito project. I have run into a weird problem. Didn't know this about Taito cabinets.
I actually rotated the horizontal monitor to a vertical setup, but now the frame sticks out the back and the door won't close.
After a little research, I've discovered that this is common and that Taito used a "shroud" to go over the hole they cut out of the door.
However, I can't find a picture of the back of a taito cab that has this shroud over it.
Could someone please upload a picture of the back of a Taito cabinet that has this vertical monitor shroud on it? I think I'm going to either have to cut the door or hack up my monitor frame.
If I cut the door, I'll need to locate one of those "shrouds" or make one, but I have no clue what they look like on the back of the cabinets.
Does anybody have a Taito cabinet with one of those bubbles on it? I need a pic to go by if I cut up my door.