Hi from New Zealand,
Hoping someone can help.
I purchased a Wei Ya 825HR4 chassis from Victor (8liners), only to have to fail within 30 seconds of powering up.
Too expensive to send it back to the States.
I powered it up with a 1940 in 1 PCB. Vert hold was out....I adjusted it all the way down to the end of the "pots" travel , and it went "POP", and now the chassis is dead.
It's been sugessted by a few people that the HOT is stuffed. I measure it on diode mode and every reading was 0.0001.
Can someone please offer a cross refernce for the H.O.T 2SC5777 that I can use, as I couldn't find one on EBay.
Do you think anythink else would have blown?
Thanks in advance
Hoping someone can help.
I purchased a Wei Ya 825HR4 chassis from Victor (8liners), only to have to fail within 30 seconds of powering up.
Too expensive to send it back to the States.
I powered it up with a 1940 in 1 PCB. Vert hold was out....I adjusted it all the way down to the end of the "pots" travel , and it went "POP", and now the chassis is dead.
It's been sugessted by a few people that the HOT is stuffed. I measure it on diode mode and every reading was 0.0001.
Can someone please offer a cross refernce for the H.O.T 2SC5777 that I can use, as I couldn't find one on EBay.
Do you think anythink else would have blown?
Thanks in advance