Hey everyone. Question for you guys. I have a picture tube where the convergence is way off on bottom right corner of screen. Tried adjusting with the rings but seems to only make minor adjustments. Also note that the horizontal and vertical are aligned pretty well in the center, and seem to get worse when I mess with the rings. I also tried using some convergence strips (yoke strips) but its just not enough to pull this picture together. Do you think the yoke came out of place? As far as I know it is in it's factory location (still has the glue around it holding it). Any advice would help, I just don't want to make it worse than it is. Thanks.
↧