I have an Open Ice machine, and 4 competition joysticks ready to install to replace the originals. The joysticks have a washer that goes under the CPO, but above the wood beneath the CPO. That washer's center hole is a bit bigger than whats in the control panel, b/c the competition joystick's shaft width is just a smidge wider than the original joysticks that came with the machine, so I've got to get the CPO off.
The plexi ontop of the CPO was screwed down with several security screws, so I figured (apparently incorrectly..) that the CPO itself was just floating free underneath the plexi.. nope.
Is that CPO glued down, are some of the screws on the backside holding it in somehow?
Any way to remove it without ruining it, so I can get those new washers in there?
The plexi ontop of the CPO was screwed down with several security screws, so I figured (apparently incorrectly..) that the CPO itself was just floating free underneath the plexi.. nope.
Is that CPO glued down, are some of the screws on the backside holding it in somehow?
Any way to remove it without ruining it, so I can get those new washers in there?